CellSol ESP32 WiFi Pylon Case for Heltec LoRa32 - Large
Description
This is a simple large case for a CellSol WiFi Pylon built using the recommended Heltec LoRa32 or V2 board. This has room for a larger battery box, such as 3 AA batteries, as well as any additional accessories such as instruments or data loggers you may wish to add. It is otherwise the same as the small case. Using silicone gasket material, silicone paint, and transparent screen protector film we were able to make this case somewhat water resistant but we do not recommend it for unsupervised outdoor use at this time. It's good for a handheld pocket pylon, however. CellSol (short for Cellular-Solar) is a long range mesh networked communication system designed for last-mile replacement in the event of a disaster or unrest. More information on CellSol can be found at https://www.f3.to/cellsol Prints fine at 20% infill PLA or PETG with 0.2mm layers. Instructions Print and screw together with 3mm screws; we recommend tapping the holes first.
Statistics
Likes
0
Downloads
0