4" Bench Vise Soft Jaws Jaw Protectors
Description
I was looking for a good STL for a set of soft jaws for my 4" bench vise. I liked the original design here, but it was too small for my vise. I started tweaking to make the design for a 4 inch vise, and wound up revising the tops, added a side piece, and added holes in back for 10mm x 3mm neodymium magnets. I superglued the magnets into place, and it now holds well to my vise, and the side pieces hold it in alignment. One item to note, the pieces are not identical, but rather mirrors of each other. You will need to print both pieces or the alignment will be off.
Statistics
Likes
33
Downloads
0