Prusa MK3 Camera Mount
Description
Compatible with Prusa MK3 / MK3s. I am using the E3D Hemera on my Printer so the Camera height has been adjusted to that specific Extruder. To check if this fits to your printer just measure the height distance between the bottom left screw on the x-Axis motor and the Z-offset the camera lens should be at. As seen in the Picture above, the Z-offset is 25mm. The camera fits nice into the mount and does not wobble. The camera used is the "kuman Raspberry Pi 4 3B+ Model B B+ A+ RPi Kamera" (found on german amazon.de) For people in the US i found "Smraza Camera Module for Raspberry Pi" on amazon.com, it seems to be looking very similar and might be the same model but i cannot confirm this. No support structure needed
Statistics
Likes
1
Downloads
0