Micro Servo Pan and Tilt mechanism
Description
Wanted to have a compact tilt mechanism to add to a simple pan mount and made this by mounting an EMAX ES9051 4.2g servo under the camera so that it pivots the whole camera mount. Be careful when wedging the servo down into the mount, I snapped the original arm that was 1.5mm thick so I increased it to 2mm thick, but if you print in PLA it's still not going to be super strong so take it slow. https://youtu.be/1f9XObQ8Wmw **Currently (V2) the camera mount area is about 21mm wide so I used some of the small M2 washers that come with most FPV cameras. I plan to update it to be 19mm wide opening.
Statistics
Likes
9
Downloads
0