Glock Man cave table lamp
Description
A remux fromthing: 3867556 from thingiverse. Added floor plate in 2 parts and hollowed out the barrel to feed the cord. I first made a variant where the cord ran through the magazine. But that went wrong with the supports Sliced with cura, supports: yes wall line count o. Otherwise the supports are almost impossible to remove. the angle of the camera could have been better, but due to the size of the print there were few other options. And the print was already on its way when I realized this. A hollow M10 tube, length about 60 mm, screws neatly into the barrel.
Statistics
Likes
30
Downloads
0