Ai3MS Hotbed Cable mount
Description
Enlarged the hole where the spring resides so that it is not over-compressing or constrained by the hole. Also increased edge thickness of the back where the bottom nut screws in as part section was too thin causing breakage in my case. Slightly decreased the gap in the V2 version for a tighter fit on the metal frame. Photo is of V2 version. Printed at 15% infill, 0.2 layer height. You can increase infill if you want a stronger part but it is fine as it is. P/S - I'm still tuning my print settings so this current print is not really great. Too much extrusion and still figuring out this brand new roll of PLA for a new manufacturer that I'm using. Overall part fit is good.
Statistics
Likes
1
Downloads
0