Ender 5 Plus BMG-M Mosquito carriage
Description
BMG-m Mosquito mount for the ender 5 plus. If your printer uses the same carriage plate that the ender 5 plus does then this should work for you too. This uses the stock BLtouch mount and you can use the stock 40mm fan but if you want the cooling fan you'll need a 5015 blower (I have not done any flow analysis of the cooling ducts). You'll need a variety of M3 bolts, I haven't checked all length so I suggest getting a variety pack on amazon for pretty cheap. You'll need three 40mm long M3 bolts to attach the BMG-m to the stepper motor. I would also recommend a M3 tap to thread the plastic in various spots before putting everything together, but shouldn't be necessary. I would suggest facing the Mosquito on the BMG-m mount with the heater cartridge on the motor side and if you haven't installed the heater and thermistor to face them towards the lever on the BMG but isn't necessary. Make sure the BLtouch is mounted to the stock bracket before installing and it is easier to plug it in now before installing it. The BLtouch bracket should slide in behind the carriage and you'll use four M3 bolts to hold it on. Next mount the BMG-m with the mosquito already attached through the carriage into the motor. Then mount the fans. Keep in mind that the 40mm fan adapter covers the bottom screws of the BMG mount so you have to pull the fan off to remove the motor or bmg in the future. You could avoid this by using the 25mm fan that comes with the mosquito. The cooling duct should go on last and you can remove it if your printing ABS. The ABL offset in marlin for the BLtouch should be -42 X offset and 12 Y offset.
Statistics
Likes
3
Downloads
0