THE Surface Pro Stand
Description
I needed a larger print to test some filament and I needed a tidier, reliable stand to store my surface pro on the desk. So I made the THE Surface Pro Stand. The wide base means I haven't had to worry about kocking it over. Most slim laptops and tablets should fit in no worries but a Surface Pro with cover should feel just right. Layer Height: 0.2 mm Material: All, PLA recommended Infill: 10% Infill Parttern: Pay close attention to your slice on the internal chamfers. A hex pattern can result in holes on the top surface due to being unsupported. Linear pattern recommended.
Statistics
Likes
3
Downloads
0