Knobs, based on: M3, M4, M5, M6, M8, M10 nuts and lock-nuts
Description
Knobs, Based On: M3, M4, M5, M6, M8, M10 Normal Nuts And Lock-Nuts (They Are A Bit Higher). After Trying Them I Decided To Make Two Versions Of Them: A Loose Fit (The Nut Can Be Pressed By Hand In The Knob) And A Tight Fit (The Nut Has To Be Pressed Or Hammered In The Knob). The M4 Knob Is Made For The Craftbot Buildplate. I Have Printed Them With Kisslicer, 0.3Mm Layer Height, 5 Loops, 2Mm Skin Thickness, 33% Infill. They Are Designed To Be Printed Without Support Structure. The Knobs Have Little "Snappers" At The Bottom, To Prevent The Nuts To Fall Out , After Hammering / Drive Them In The Knob. Scale / Adjust The Inset Parameter Of Kisslicer To Fit Your Specific Printer Needs.
Statistics
Likes
1251
Downloads
0