SCX24 Deadbolt LED Lightbar
Description
I made this to fit 5mm LEDs, it looks almost like the stock one but lights up! I sliced the model with the front of the light bezels level to the plate on the bottom, with supports. I had to print on a raft too to make it stick better. Depending on print resolution the small flats next to the screw holes might need sanded for fitting. I printed out the front and rear bumpers and light buckets from @themikesterdesigns, and this compliments them well. I also added a Sharegoo LED controller, so channel 3 can be used to switch the headlights and lightbar on and off with the transmitter. edit- I added a closeup photo of the wiring on the top side, I used heat shrink tube to cover the wire connection and bind the wires to the passenger side A pillar to conceal the wires.
Statistics
Likes
18
Downloads
0