Doll Computer Desk (1/3 BJD)
Description
A computer desk for a 1/3 scale BJD. Print two of the main part, and four feet. To complete the desk you'll need a couple of small sheets of 3mm ply (or similar) which you can varnish/finish are you prefer. Cut one a little shorter, and size to fit in the notch on the vertical part of the frames (roughly 240x150mm). This forms the back, and provides most of the strength. Then just glue a slightly larger piece of board (210mm/x300mm) to the top. Unlike most 1/3 scale stuff, its fast to print, and the parts are sized to fit on a standard sized (220x200mm) bed, though they will go right to the edge so make sure you can print all the way to the edge - I discovered my Y end-stop was about 20mm out, and had to work around some mounting holes. See my other designs for the computer case and monitor stand.
Statistics
Likes
39
Downloads
0