Speedloader for Savage 64 - Remix
Description
The original design worked nearly perfectly, though I encountered a couple of issues. 1) The plunger was fragile and kept breaking off and 2) the front edge was a bit too tall and made it hard to seat the round after loading it. This version employs a beefed-up plunger so it is less prone to breaking, and the front edge is cut lower for easier access to the rounds. One important printing note: Support settings are critical for a successful print. Specifically, you should use support from the baseplate, and set the x/y offset to 1.5mm. That will prevent the slicer from creating support behind the plunger. Otherwise it is very difficult to remove the support after the print. Also set the infill way up to provide extra strength for the plunger
Statistics
Likes
7
Downloads
0