NEMA-17 Peristaltic Pump V2
Description
A New And Improved Minimalistic Peristaltic Pump For A Nema-17 Stepper Motor. For Motors With More Power, Use The U Enclosure To Minimize Backflow. The Pump Output Is 1Ml/9Rev. Improved: Center Hub Changed To Spring Arms To Allow For Printer Inconsistencies And Prevent Binding Of Motor. This Means Smaller Steppers, More Bearings, Or Lower Quality Bearings Can Be Used. Center Hub Also Uses A Nut For The Set Screw To Prevent Accidental Stripping. Bom: Five M3X8 Screws One M3X16 Screw One M3X20 Screw One M3 Nut (Optional) Four M3 Washers Four 8Mm Od, 3Mm Id Bearings One Nema-17 Stepper Motor (At Least 3 Kg/Cm) 2Mm Od, 1Mm Id Soft Silicon Tubing To Buy One Check Out My Store On Tindie. Https://Www.Tindie.Com/Products/Copabx/Nema-17-Peristaltic-Pump-Kit/ Build Instructions Http://Www.Instructables.Com/Id/Nema-17-Peristaltic-Pump/
Statistics
Likes
367
Downloads
0