EK Phoenix 240 Minimized Shroud Mount for Ghost S1/SFF Cases
Description
All holes are for 3mm screws. This is a snap fit, it will support front, top and bottom mounting however for top mounting i would reinforce it with some silicon adhesive or hot glue if you intend to use this in a mobile setup. Due to the relatively thin shroud walls that snap around the radiator, I would not recommend it to be side mounted unless you epoxy the fan frame to the radiator. Dimensional accuracy is very important this is an extremely tight fit you may need to play with scaling a bit on various axis if your printer does not have good dimensional accuracy. Print Settings: 2 Walls 3 Top 3 Bottom 20 % infill
Statistics
Likes
0
Downloads
0