Runcam5 Case with Gopro Mount
Description
I recently bought a Runcam5 Orange as a cheaper and smaller alternative to a GoPro. It has almost the same dimensions as a Gropro Session, but has chamfered edges instead of rounded edges like the Gopro. There are a lot of good designs out there for the Session, but because of this they did not quite fit the Runcam5. I decided to design my own case and it fits like a glove. It is easy to print. I use a small M2 screw to hold the lid in place, but a piece of electrical tape could provide enough friction to hold the lid without the screw. Would recommend using the screw though. I made 2 different lids, a solid one to prevent dirt from getting into the mesh on the back and one with a hole there. All features of the cam are accessible with the case on, the microB charging cable fits, the on/off button can be pressed and even the sd card slot can be accessed. In the future I might add a version where the charging port is closed off to prevent dirt coming into it.
Statistics
Likes
1
Downloads
0