ACR J10 Angled Foregrip
Description
Im printing this at the moment in two pieces, theres probably nothing too special about this grip and it may even be a piece of junk.. I just wanted to have a shot at designing one. about 120mm long and 60mm tall. I have tried to make the grip hug the handguard a bit tighter so not sure if it would fit on any other guns. After printing this i found the gun wasnt as tight as i would like, so ive adjusted a few minor measurements to try and fix this. Tried printing as one piece but had no luck:( V3 Changed the pin hole height by 1mm to try and make grip a bit tighter to rail. Added the Picatinny rail ive used to mount grip. Added some decal to the side to try and match the gun a bit.. Changed pin hole configuration.
Statistics
Likes
3
Downloads
0