Print head direct e3d v6 Sapphire Pro
Description
Direct Drive Extruder mount for e3d v6 for Sapphire Pro. Print Settings: 4 Walls 5 Top 5 Bottom 15 % infill The parts are positioned as they should be on the print bed. Supports are needed only for printing Head in front, only from the table, distance x and y 2mm, use the roof of supports with 100% density. I recommend the material ABS, as it is lighter than Petg and more heat-resistant, it is easier to separate supports. The pre-tensioning of the belts is done with two wedges. The final tension to the desired level is done by shifting the axle motor brackets. When using good belts, this only needs to be done once and then used for a very long time. I consider it absolutely pointless to place the belt tensioning system on the head.
Statistics
Likes
25
Downloads
0