Reusable Gingerbread House
Description
HAS THIS ever happened to YOU?? Gingerbread house pieces not sticking together...breaking in to pieces...drying lopsided....being EATEN!!!! IF SO, then this 3d PRINT IS FOR YOU!!!! This will be the end of gingerbread! Easy to assemble gingerbread house with snap together parts that require no support to print. Best of all, when the season is over, take it apart and clean it off or throw it away and print a new one for next year! Print the following parts: 2 x Side 2 x End 2 x roof To assemble: 1. Set the first roof piece flat upside down 2. Set both ends in the grooves on each end of the roof piece 3. Snap the first side piece in to the grooves on the ends and slide it into the groove on the roof 4. Set down the second roof piece, flat and upside down 5. Rotate half assembled structure on to the second roof piece and align ends in the roof grooves 6. Snap the remaining side piece in the grooves on the ends and slide it into the groove on the roof
Statistics
Likes
14
Downloads
0