Anet A8 Screwless y-axis motor mount
Description
I added a stepper motor dampener to the motors on my x and y axis to reduce resonance and try to cut down noise. It works pretty well but unfortunately the print bed will then knock into back of the y-axis motor (at least with the dampeners I have). It's just a few milimeters, so to combat this I decided to make a mount that I could place by hugging the rear frame rather than by screwing into the plexiglass. There is a chance that this could move during printing without the addition of some hot glue or something. But it allows you to position your motor to avoid the moving build plate. So far it's been pretty snug.
Statistics
Likes
0
Downloads
0