Geeetech Fang Cooling
Description
The design here was adapted from the Fang cooling design to fit the Geeetech A10 hotend and carriage since the other models on Thinigiverse were not compatible with this printer. The Model can be printed in 2 pieces without support and an optional 3rd piece if you have the BL-Touch or any of its clones. Assembling: -Attach the 40x40 mm fan to the hotend mounting piece -Insert the hotend from the bottom up and screw it in using the same screws -Screw the hotend mounting piece to the x-carriage of the printer taking care to place the thermister and hotend wires in the small notch in the design. -Push the 5015 fan into place and secure it with one screw -If you have the BL-Touch ---Attach the BL-Touch to the BL-Touch mounting piece ---Slide it into position and push it all the way down -Slide the Cooling ducts into place (its a tight fit) taking car not to place pressure on the actually ducts so they don't break. IMPORTANT: Make sure to recalibrate you probe offsets (mainly the Z) so your printer doesn't accidentally print into the bed plate and ruin it (learned that the hard way) Hardware: -40x40mm fan with screws (4x M3) -5015 Fan --Screw (1x M5) can be found in geeetech's spare screws
Statistics
Likes
10
Downloads
0