Towel Holder | Handtuchhalter (REMIX) for 3M Command Strips
Description
<strong>This is a remix of msCreations' Towel Holder (Hook_sturdy version)</strong>. It was designed to be used with 3M Command Strips (large size), which will need to be be cut down slightly for length (I would not cut the tab down as much as shown in the pics since it makes it harder to remove). This design uses 2 parts, the first mounts to the wall using the Command Strips, and then the towel holder slides on to that. There is a bit of a latch near the base of the holder to keep everything secure, but I suggest adding some glue to make sure it stays together or it may slide off the base. The "V" groove on this remix was changed just a bit to add a slight radius, and some bumps to narrow it a bit more, but it is otherwise pretty much the same as the original. <h1>If you have little ones, I do not recommend using these since they could get their fingers pinched or stuck. In any case, this is a make / use it at your own risk thing.</h1> I have an updated version here, which is angled (which may help if it is placed next to a oven or dishwasher door): https://www.thingiverse.com/thing:4880027 STEP file is included, and the parts may need to be oriented for printing (no supports are needed).
Statistics
Likes
33
Downloads
0