Nerf Mega Titan Magazine XS
Description
I'm currently building one of Captain Slug's 2nd Degree Megaburns and quickly realized that I needed some sweet mags to complete it. I've enjoyed some of Xero1Tec's other designs for the Rival Takedown. When I saw that he had designed a mag for Mega darts, I was all in. Unfortunately, I use a Prusa Mini. The side walls for the 9-round Titan are too large for my print bed, without some fancy maneuvering and lots of supports. Cap that off with the layer orientation making it too weak to be viable... I used my meager skills in Tinkercad to carve out the middle sections of the left and right side models, roughly 5 cm. That shortened them up just enough to allow them to print on my smaller print bed. The base and follower are Xero1Tec's X1T_Titan_9_Base and X1T_Titan_Follower and can be found in his original fileset. I printed these at 0.1 mm because I like the finer resolution, but I'm sure you could print them at 0.15 or even 0.2. I used 30% infill for the sides, 50% for the base and follower. The finished mags can hold 5 rounds and still use all the same hardware as the original Titan mags.
Statistics
Likes
0
Downloads
0