CR-10 heavy duty E3D V6 mount direct drive extruder mount
Description
This is my addition to a very cool E3D V6 mount for CR-10: https://www.thingiverse.com/thing:2494642. This part mounts using 2 screws to the CR-10 hot-end plate: the lower one of those that would normally mount the CR-10 hot-end housing and the left wheel screw. Additionally, it mounts with a single screw to the modular mount's cover. It keeps the extruder right above the hot-end. Some modification may be needed depending on your extruder. The source OnShape model is here for tinkering: https://bit.ly/3arKl8H I consider it still WiP, although it has been working well for a number of short and long prints already, so I will likely not make any changes. See drawings and photo for reference configuration.
Statistics
Likes
6
Downloads
0