16D Anglewinder chassis
Description
This is a 16D enabled Anglewinder slotcar chassis. It takes a 31T axel gear and an 8T pinion gear on the motor. Meshing the gears my be difficult. If it is a little tight, anglewinders tend to wear in, or you can try changing the gears by one tooth, until it feels right. When you mount the motor, use screws with larger heads, or use washers, so they don't pull through the plastic. If you use a high output rewound motor, you will need to put a little dab of glue to hold it to the frame, because you can only tighten screws on PLA so much before they pull through the plastic. The Lexan body is held on the way they used to do it "back in the day", 1968, with pins that are slightly bent, so they bind up a bit. Put tape over them so they won't fall out. Glue the guide holder where you want it, add all of the usual slotcar parts, and you're ready to go.
Statistics
Likes
2
Downloads
0