Upgrade servo mount for Axial SCX24 (EMAX)
Description
This item is a servo holder for the Axial SCX24 specifically designed to fit the EMAX ES08Mx servo. It comes in two different versions: A) One piece version requirering advanced support to be able to print it with success B) A two piece version where each part is easily printed without support but needs to be clued together to complete the servo mount. All holes is assumed to be drilled out with an 1.1 mm drill bit to allow self-tapping use of the original Axial 1.4 mm screws. NOTE 1: I went with alternative B and printed the parts in high quality ABS and used thin layers of UHO por on each part (contact glue) to glue the parts together (applied with a used hobby knife blade). NOTE 2: The digital version of the EMAX ES08M servo may generate high current surges causing the voltage output of the RX/ESC AE-6 voltage regulator to brown out. Especially when the D/R is not trimmed to avoid hard-over. To mitigate this the analog version of the ES08M servo is recommended. In addition, to allow symmetrical steering the lenghts of the steering rod should be increased. A demo video may be found here: https://www.youtube.com/watch?v=22-vtG0CIYs UPDATE 2020-12-30 NOTE 3: Forgot to mentioned that the upper corner of the attachment tab on servo case (and possibly the holder as well) should really be grinded / cut off at a ~ 45 deg angle (I used a file). This is to minimize the risk of the servo tab touching the frame and obstructing the movement. I have attached a new photo showing this.
Statistics
Likes
26
Downloads
0