Pen cap (Pilot FriXion ball)
Description
I made this replacement pen cap for a "Pilot FriXion ball"-pen in Fusion 360. It is almost identical to the original in terms of look and fit. ##Printing: One problem with the pen cap is that the clip is very weak when printed vertically. If you wish to use the clip, I recommend printing the cap at an angle or horizontally (if you don't mind removing a lot of support material), otherwise, it will most likely snap. This is at least my experience when printing with PLA. I get very nice results when I print the cap standing on its tip, tilted 45 degrees, and with the clip located on either the right or left side of the cap. This uses less support material and makes the clip quite strong but also flexible.
Statistics
Likes
4
Downloads
0