Anker PowerCore Speed 20000 PD Tripod Leg Clamp - for Manfrotto 055 Tripod
Description
Clamp to hold an Anker PowerCore Speed 20000 PD on a Manfrotto 055 tripod leg. It should also fit any other tripod with a leg diameter of 30 mm. This might also fit other Anker PowerCore products with similar measurements. For reference, mine is 62.2 mm wide and 22.4 mm thick. This is a two-part design. The lower clamp has a solid base to hold the power bank's base; the upper clamp holds it on top. I highly recommend printing in PETG. I highly recommend printing in PETG. The tolerances are pretty tight for the clamp to hold the power bank. It's a really solid snap getting the clamp on and off the tripod leg so that the stiffer PLA might shatter. Also, for outside applications, PETG makes sense for its higher heat resistance. Video: https://www.reddit.com/r/functionalprint/comments/kgzpuw/battery_holder_for_timelapse_photography_with/
Statistics
Likes
18
Downloads
0