BTT 2in1 Out for Creality CR10 and others
Description
13/02/2021: updated the design a little, made the cable guide in the top screwed as having to cut cable ties each time was a pain. BLT has been added to the back, i used an online model which turned out to be longer than the 3d touch i used. to combat this ive added some spacers to increase the offset for what you need. i have a 3d touch from geetech and needed the 4mm spacer. BLT offsets are X +21.73, Y+30.22, Z-4.05 made this as i didn't see one that i liked, had a spare blower fan laying around so made a duel design, you could quite easily leave one off as it still directs some of the hotend air up and away. i just superglued the bowden and cable guide on the top. Make sure the bowden doesnt stop the extruder sitting flush
Statistics
Likes
7
Downloads
0