Wanhao D12 BLTouch mount
Description
This mount was designed to install a BLTouch on a Wanhao Duplicator 12. It is based on the Bl Touch mount for wanhao I3 plus made by Gubbi24 licensed under CC BY 4.0 (https://www.thingiverse.com/thing:3680098). You can find BLTouch installation instructions (in French) here : https://www.youtube.com/watch?v=N_Xe__Rds9I For the original Wanhao D12 (grey version), you will need to update the robin_nano35_cfg.txt file by setting INVERT_Z_DIR 1 to INVERT_Z_DIR 0 before installing the firmware! Please be careful to always be ready to stop the printer (to avoid damaging your bed or printer head). I connected my BLTouch to the Z- pins (instead of the Z+ on the official Wanhao video). I used 2 M3\*7mm, 2 M3\*4mm screws and 2 M3 nuts to mount the BLTouch and the support. I also removed some material from the BLTouch that was touching the 4mm screws. You first need to attach the support to the printer head using the 2 M3\*4mm. The M3\*7mm and M3 nuts helps attach the BLTouch to the support.
Statistics
Likes
31
Downloads
0