Satsana Dual 5015 Fan Duct With BL Touch Mount for Ender 3 (Stock& Microswiss Hotend Compatible!)
Description
Here is a dual 5015 fan Satsana remix with a BL Touch mount included. I based it off this remix ( https://www.thingiverse.com/thing:4548894 ), so the offsets should be about x: -55.1 and y: -18.4 . If anyone discovers they are different, comment and i'll edit this description. I designed this mount to have proper clearance for the x-axis limit switch, so no need to worry about that. You will need two 5015 Blower Fans and 4 M2 20mm screws. 2/13- Uploaded v2 edit with reduced amount of plastic where the right screw that mounts the fan duct is located, as well as angled the edge of it. This should help add a little bit of space and make unscrewing/screwing the ptfe tube connector a bit easier. Apparently it is Micro Swiss Direct Drive compatible as well. **Note** There is a 1mm gap between the fan and the left side of the left Satsana fan opening; I noticed the gap in the picture after upload, so I fixed the stl immediately and reuploaded the file.The BL Touch mount was modified and moved left 2mm to make some space for the connector on the BL Touch, and the fan opening was tightened by 0.5mm. There should be no issue with that gap in your prints. Enjoy!
Statistics
Likes
94
Downloads
0