Creality Ender-3 Cable holder
Description
This cable holder for the Ender-3 V2 keeps the cable to the nozzle clear from the print bed. While making my first prints on the Ender-3 V2 the cable that runs to the nozzle got stuck between the printbed and the motor that is situated in the rear of the printer. To prevent this from happening I designed this cable holder. The cable holder is attached directly to the printer. To do this you should remove the plastic cap at te left hind side of the printer (see picture). You can attach the cable holder using 2-4 bots, which should be of M4 size and have a length of 1-2 centimeters. I did not have bolts with a small enough head (and due to the corona lock-down I can't go to the store to get them). But I will replace them when the shops re-open. The holes for the screws need a little support to print (see picture). I have included them in the design. I printed mine without these supports. With these supports printing should be better, but please let me know if I need to adjust them. After printing, remove the supports before fitting the bolts. I also provided the g-code for the Ender-3 V2 printer, if you want to generate it yourself, you do not have to add additional supports. While printing the upper end of the holder got detached from my printerbed, so it might to wise to use some adhesive spray before printing. Otherwise mine came out just fine (only with non-intended rounded edges at the top).
Statistics
Likes
2
Downloads
0