Tiger Tank Breakdown Remix
Description
I printed the original Tiger Tank Breakdown by chanson836 at 2x scale on my Ender 3 Pro. After 30 hours and 18 minutes I found out that I had printed the wrong tracks, and that the geometry of the bottom hull obstructed the front hull section so that it would not sit flat without sanding/grinding. I modified the lower hull so that the front hull piece would sit flush, I also added some filler on the front hull section so that there will no longer be a gap underneath it that you can see through. I used the tracks bertmern made https://www.thingiverse.com/thing:4133923 for TigerAce1945's models. If you use the bertmern tracks you will need to scale them to fit in your slicer and also sink part of them into the build plate so that some unneeded geometry is cut off.
Statistics
Likes
10
Downloads
0