Steering / Throttle Lever for WLToys RC Radio 10428 (949 - 959 - 969 - 989 -...)
Description
This part is used to bring back your WLToys radio's wheel on centre when you release it. I used PLA+ for this part because I can't print ABS at this moment. (220°/60°) To reduce the fragility of the part, I designed the part with a thicken of 2mm instead the 1.8mm of the original part. If you have only PLA, you can easily change the thicken of the part with your slicer. I recommend to not exceed 2.4mm. If you print at 2.4mm, it's possible to listen a "clic" each time you will release the radio's wheel, but it will disappear after 2 or 3 sessions.
Statistics
Likes
9
Downloads
0