Allen hex key handle
Description
This is simple two part ring and 1 screw locked allen aka hex key handle. Those small hex keys are fiddly to use if you need many turns, so decided to make a handle for metric common sizes. Anet A6; Printed with 0.6 mm nozzle; 0.2 mm layer height; 40 % infill; 3 top, 3 bottom, 3 perimeters; No support. Assembled by press fit of the ring and one small M2.5 bolt or small screw. If allen key is too tight it is a good idea to heat a bit allen key and then press it into place, so it molds it's way in. If the ring does not fit, scale it up by 1-2 %, if too loose use super glue. Mine went by press fit, holding tight.
Statistics
Likes
14
Downloads
0