Super Simple HexaLeaf RGB LED Lamp
Description
My super simple version of HexaLeaf/NanoLeaf lamp. Printed with PLA at 0.2 layer height.100% infill, no support, no brim. [Demo Effect 1](https://www.youtube.com/watch?v=CvlnMwfeWk4) [Demo Effect 2](https://www.youtube.com/watch?v=QG9V2y2I-PM) [Demo Effect 3](https://www.youtube.com/watch?v=44Pv0quxs78) I have not placed any wholes in the base so it can be arranged in any way, then the wholes need to be drilled for the interconnecting cables. I glued the pieces together with CA glue. I cut a [WS2812B LED Strip ](https://www.banggood.com/DC5V-1M-144LED-WS2812B-5050SMD-Built-In-IC-IP20-RGB-LED-Strip-Light-for-Indoor-KTV-Hotel-Bar-Home-p-1509719.html?p=8Q2413595967201405P9&custlinkid=1541461) into pieces and glued them in place, then connected them with wires. The face plates are simply press fit in place. I used [ESP-01 microcontroller](https://www.banggood.com/Upgraded-Version-1M-Flash-ESP8266-ESP01-WIFI-Transceiver-Wireless-Module-p-979509.html?p=8Q2413595967201405P9 as its small enough to fit inside the base and powered it from a USB Power Bank through a tiny [3.3v power supply](https://www.banggood.com/DC-DC-800mA-BEC-UBEC-AMS1117-Power-Supply-Regulator-Sensor-Step-Down-Module-p-1336851.html?p=8Q2413595967201405P9) that is also fitted inside the base. I programmed the ESP-01 microcontroller with [WLED firmware](wled.me) so it allows a huge selection of patterns.
Statistics
Likes
74
Downloads
0