Pocket Operator Impostor Knobs and Crank
Description
This in my take on little knobs and a Crank design that can rotate the entire extension without colliding with the knob on the side for the Teenage Engineering Pocket Operator. This is part of my 3D Printed Cased "The Impostor". Available on my Etsy Store soon (at some point of January 2021). If you like Pocket Operators and this design. There's more at my instagram : http://instagram.com/kumodotdesign Here's my etsy page : https://www.etsy.com/shop/kumodotstore I printed the Knobs on PLA, 0.2 height on my Prusa Mk3 and on my ender3 V2. Depending on the printer, you will need to make adjustments to the inner walls of the knob and crank. You can change it on the model and print again until you have a perfect fit (not too tight not too loose) or just sand (or use a round file) to make the adjust. Those parts will be available to buy as a separate product on my etsy page soon. (And i test and adjust all of them before shipping). You are free to download and print yourself if you want too. Please does not resell it. (You can print for friends of course). ATTENTION : MAKE SURE you don't force it to fit in your Pocket Operator Knobs, otherwise you will have a hard time removing it later, and you could damage your PO hardware trying/forcing to remove it. You are responsible for the use of the part. It should fit not too tight not too loose. If there's much resistance while pushing it in, remove and sand a bit the inner walls to adjust.
Statistics
Likes
4
Downloads
0