Green Man Planter (vase mode)
Description
Print in vase mode. Not sure if it's the slicer or the printer but do have tiny holes over the near horizontal areas. I designed my own 100mm x 100mm plater and added the Green Man from https://www.thingiverse.com/thing:2242342 to it on all four sides. I haven't used it yet so I would slowly fill it with not too fine planter soil and hope it doesn't fall out those holes. On the plus side the would provide a tad drainage but I will drill 3 or 4 holes in the bottom in any case. That way I can rather put the water in the saucer where I will place the planter, or even print a special saucer and seal that up.
Statistics
Likes
7
Downloads
0