FLSUN QQ-S - Enclosure
Description
Enclose for the QQ-S/QQ- Pro You will need: Acetate 50x70cm 0.7mm thick - 3 sheets Printed parts: - 4x door side - hinge side (I joined all 4 together in a print with small linkages for stability) - 4x door side - non-hinge side (I joined all 4 together in a print with small linkages for stability) - 2x base side LH - 2x base side RH - 2x top side LH - 2x top side RH - 1 x all other parts I printed at 0.3mm layer height on the FLSUN QQ-S Pro with no supports I recommend attaching the door section on first before the sides I used back duct tape to hold the shape of the acetate on the side sections to the towers I used 10mm magnets for the side pieces and door - will also take up to 20mm magnets
Statistics
Likes
123
Downloads
0