Engine - Print in Place (Wave pattern, Cross Plane)
Description
Designed as a print in place with a few break-away bridge structures so it does not need supports enabled. If you print it, please let me know how it goes! Also see the break in procedure outlined down below so you don’t snap the crankshaft right away or something This version will do a "wave" pattern with the pistons when rotated My best results have been with these settings: 0.4mm nozzle 0.2mm layer height 200C nozzle temp 60C bed temp 20% infill 40mm/sec speed
Statistics
Likes
17
Downloads
0