Cyclone PCB Factory Mods
Description
Here are a couple of modifications I did when building the CycloneCNC [1]. * The X-Y motor gears were quite loose when attached to a Nema 17 motor therefore I shrunk the hole a bit. * Modified the Z motor gear so that I can use a 8 mm M3 screw (I had no grub screw). * Enlarged the vaccum cleaner attachment since it did not fit onto the vaccum cleaner I had. * Created a cap for the endstops I used. [1] https://github.com/CarlosGS/Cyclone-PCB-Factory/wiki
Statistics
Likes
1
Downloads
0