SKR Board Case
Description
Here is my remix of a MPCNC MKS Gen L Case by aslak3. I have remixed this for my MPCNC Lowrider which I am using a SKR V1.3 board with a MKS TFT28 screen. Sorry about the orientation of the files, I'm still learning how to CAD. You will have to lay them flat on the top and bottom, no supports are needed. The changes I made: Closed up holes on the sides, top and back that I didn't need for my build. Added a slot on the front bottom for removing the micro sd card without having to remove the board from the case. Resized the screen opening to fit the MKS TFT28 screen. Added a rectangle opening in the back for wiring board. Finally I counter sunk some 6/32 hex nut holes in the bottom for board attachment. EDIT: I have increased the sd card hole size as it was too hard to remove the card. I have also uploaded the .step file for your remixing needs. EDIT: I have uploaded another file titled SKR top. In this version there are 20mm holes on each side of the case to run wire bundles into the board. I was having a hard time routing my wires through the rectangular hole in the back. Enjoy and remix to fit your needs.
Statistics
Likes
1
Downloads
0