Pencilbox for Stabilo® Adventskalender 2020
Description
This is a pencil organizing box for the german brand Stabilo® advent calender. https://www.stabilo.com/de/stories/kreativer-adventskalender-2020/ The printed box fits inside the factory cardboard box and is split in two pieces for printers with smaller build volume. This was printed with single layer walls (in Cura: Special modes - surface mode: Surface) and for sucessful adhesion to the printing bed with a raft of +1mm. If you want to keep the floor on the box - change the raft air gap to 0mm otherwise it will seperate from the walls after finishing the print. To reduce printing time and material - set the raft top layers to 0 and print just one base and one middle layer. The Part A with the smaller grid is very sturdy, but part B with the longer walls is a bit flimsy and a bit of warping is likely to occur. should not matter too much inside of the cardboard box. EDIT: Raising the Parameter "Extrusion width" produces thicker walls and could help with the wobbly walls ;)
Statistics
Likes
15
Downloads
0