project voron-01 sffpc case
Description
Here are the files for project voron-01 3D printed case, built using five 3D printed parts and two 300mm makerbeam extrusions. For more photos and information visit the links below: .step and .skp files here: https://drive.google.com/drive/mobile/folders/1CSIufqUkRCGKRou9RIQ7jEQwn3_7JbYk?usp=sharing https://www.reddit.com/r/sffpc/comments/kqtuzp/project_voron01_3d_printed_case/ https://imgur.com/gallery/9idQPV4 Other required parts beside the prints: 2x makerbeam 300mm extrusions 1x makerbeam T-bracket (or print derivative to secure PSU) 1x 6-32 to M3 6mm standoff (some PSU's have regular M3 thread so check before) 2x M3-12mm standoffs 5x M3-8mm standoffs 1x M3-25mm stadoff 2x M3-25mm bolt (tapered head preferably, secures extrusions to bottom part) 2x M3-15mm bolt (flat head preferably, secures extrusions to bracket part) 4x M4-25mm bolt (secures bracket to top part) 2x M4-15mm bolt (secures GPU to bracket) 1x 12mm vandal switch + jumper connector for power switch 1x right angled IEC C13 cable 24cm or longer PCI-E riser cable M3 nuts and coin washers, M4 nuts Compatibility: standard ITX spec, M-ITX motherboard, SFX-L PSU, 50mm tall CPU cooler, 310mm/2.5 slot GPU, two 2.5 inch SSDs. Dimensions: 380x200x140mm, shell is 4mm thick, 12mm power switch cutout. Top and bottom parts are secured like a capsule using M3 screws at both ends of the extrusions. The makerbeam extrusions come pre-cut and tapped, no modification is necessary. Print was done using PLA+ on a FLSUN QQ-S (upgraded fan duct and replaced stock timing belts)
Statistics
Likes
409
Downloads
0