Oculus Touch Gunstock - Quest / Rift S Cups
Description
This is a simple design for Quest/RiftS Touch controller cups based on [this design](https://www.thingiverse.com/thing:2057419/files). The controllers have a tiny bit of wiggle room, but most of your fingers hold onto the cups anyways, so they won't slide out. They should pop through with a bit of resistence and just perfectly slide in afterwards. You definitely feel the cups, but they're not uncomfortable. Some more technical stuff : The 3 smaller holes are for magnets. They should fit 8mmx3mm. We used 6x3mm (N52) and they're a bit too weak to hold the weight sadly. 7mm will definitely fit though. Just hot glue them into the holes with a single drop. **Also make sure to line up the poles of the magnets!!** I used Blender and the SteamVR Render Model of the Quest1 Controllers.
Statistics
Likes
1
Downloads
0