Phoneitin, A Simple Wall Phone Mount
Description
The Phoneitin! (Pronounced Phone-it-in) A Simple wall mount for cell phones. Got the idea by perusing a daily sale website, thought the asking price of $15 was a bit excessive and decided to make my own. Works great, prints fast. V1 takes approximately 1.5 hours V2 takes approximately 2.5 hours. Both models include a hole for an M3 pan head screw, or you can slap a couple Command strips on the back and slap it on your wall. I'll upload more of these to fit the most popular phones. This is tested to fit an S20 with case, S20+ with case, S20FE with case, and an S20 Ultra no case. However, based on dimensions alone, this should fit the vast majority of large screen phones. 2 Version files. V1 is not marked as such, V2 is marked and is slanted, lending to a decline to slip phone into instead of parallel with wall. A third file was added with no text on model, but is the same as V2. Version 1 Nominal Dimensions: *(all dimensions within a degree of accuracy of +/- 0.15mm) Inset: 15.60mm Height: 65.50mm Width: 88.80mm Thickness: 3mm Version 2 (slanted) Nominal Dimensions: *(all dimensions within a degree of accuracy of +/- 0.15mm) Inset: 15.50mm Height: 70mm Width: 88.80mm Thickness Top: 3.2mm Thickness Bottom: 8.5mm (due to slant) Print "standing up". Printing flat will require supports and is generally a pain in the תחת (tuchus, butt, rear end, backside....etc) More pictures will be added after each model is printed. Lemme know how your print goes!
Statistics
Likes
0
Downloads
0