Propeller for Cure and Wash Station
Description
This is a ball bearing Propellor for your Wash and Cure Sation. Actually it fits with the Elegoo Mercury Plus Wash and Cure Station. I dont know the dimension about the Anycubic Wash and Cure Sation but i think they are the same. What you need: - Ball Bearing 8x22x7 [mm] [inner X outer X thickness] - 4 Magnets 10x2 [mm] You have to glue the Base into the middle of your Wash Container U can glue the Magnets and the ball bearing too. Otherwise you can also heating up the Propellor and cool down the ball bearing and the Magnets and stick them together. Be careful with Heating up i heated the Propeller on my FDM Printer too 100°C After sticking the Parts together cool all Parts down and Stick the Propellor to the Base. If its not sticking enough together (Base and ball Bearing) you can also use a little screw to expand the Base. Thats it!. Have Fun!
Statistics
Likes
38
Downloads
0