Bender pen holder 2 part REMIX
Description
I had a few problems with this pen holder, namely: 1. Long print time: I didn't want to leave my printer working for 24+ hours without supervision. 2. A lot of supports needed: I split the model into two parts, so not as much support is needed. 3. Failing mid-print: I'm not sure why, but the print kept failing on me, so I wasted a lot of filament. So I decided to remix it. I had success using brim+tree supports touching everywhere for the first part, and brim+regular supports for the second part. The only other problem I encountered was the leg ends warping, but that is probably due to me using ASA, rather than PLA. I recommend using PLA instead, if you can.
Statistics
Likes
10
Downloads
0