Longboard wall mount
Description
This is a wall-mount for the final generation of the boosted board. I assume this will work with any boosted board/ longboard that has trucks wide enough to fit on the mount. This mount is likely overbuilt but I wanted to reduce the likelihood of failure of the mount and the attachment to the stud in the wall. Print settings I used 0.55 Nozzle PETG (Hatchbox Black) 0.48 Layer height 25% infill Supports: Yes Wall Line Count: 4 ie. 2.2mm thick walls Recommended Hardware: 2.5~3 inch coarse-thread screws
Statistics
Likes
1
Downloads
0