Ender 3 Valve Index Wall Mount
Description
Hi, so I wanted to print this wall mount for my valve index, but the original model won't fit a ender 3, unless you print it sideways, but then you need to use 3x times more material and the print time will be huge... So I made a small cut where the headset rests, so it would fit my printer. I've printed at 0.28, and I've also shared the gcode I've used (but I recomend using your own, since my printer has some upgrades and is well calibrated, so it may not print well in yours), it printed in 16h no supports. I had a bit of warping though (not that is noticeable after print is done), but thats because my room was really cold when I left it printing.
Statistics
Likes
2
Downloads
0