MakerGear M3-ID BuildTak FlexPlate System corner parts
Description
I recently purchased a BuildTac FlexPlate System for my MakerGear M3-ID dual-extruder printer. The system comes as a kit with a magnetic base that gets glued down to the heated print plate, a flexible steel plate that attaches magnetically to the base, and a BuildTac sheet that gets glued onto the steel plate. This is a WONDERFUL addition to my M3-ID, but it requires some modified parts for full functionality. The stock corner blocks and hold-down clamps are replaced with the parts I supplied below. After the modification, the flexible steel plate can be simply slid into place against the back corner stops, and gently dropped onto the base, with no fear of mis-registration or warping. I printed the hold-down clamps on my Prusa MK3 suing 0.15m Quality setting, and the corner blocks were printed on my M3-ID using the normal 0.2 mm layer setting. See the [companion post](https://www.fpaynter.com/2021/01/makergear-mk3-id-buildtac-flexplate-system-installation/) on my blog site 'Paynter's Palace' for more details
Statistics
Likes
0
Downloads
0